Updating stack firmware

If there is new firmware available for the Base hardware block in your stack, you will see an alert message in the top right of Stackbuilder. Clicking the “x” will close the alert message.

When you want to update the firmware in your Base, under the “Utilities” pull down menu, select “Update Base Firmware”. The console display in the bottom rail will display progress. Downloading the update to your stack can take around 5 minutes. Make sure you do not disconnect the power or USB cable during the update.

After completion, you will need to unplug the power and USB cable from your stack, then re-connect them.

Firmware for other hardware modules can also be updated if recommended by Interstacks support. Place only the module to be updated on top of the Base module, then under the “Utilities” pull down menu select “Update Module Firmware”.

Please email info@interstacks.com with any questions.